An important point of the bubble film roll making machine is that when operating the machine, the operator cannot stand in front of the machine, so as to avoid the accident of the machine and cause damage to the operator. And when feeding, it is strictly forbidden to transfer the raw materials containing metal impurities and other hard objects that will damage the machine into the machine barrel. When operating the rotating machine, it is forbidden to wear gloves to prevent injury from being involved in the machine.

Secondly, before operating the bubble film roll making machine, check and add lubricating oil in the reduction box and air compressor, and check the lubrication of the mechanical rotating parts to avoid the parts being too dry, which may damage the machine and make noise. The manufacturer of bubble film roll making machine tells you that at the same time, it is necessary to check whether the power supply wiring is disconnected, leakage, and whether the instrument is damaged. Before operation, all parts should be guaranteed to be safe and normal to avoid production accidents.
Furthermore, the molding temperature, the cooling air temperature, and the blow-up ratio should be increased within the range of the film-forming conditions. And when the film buckle is uniform, it is necessary to wear gloves to slowly pull the tube blank, and at the same time close the port, slightly open the air intake adjustment valve, put a small amount of compressed air in the center hole of the mandrel, and then carefully guide it through to stabilize it. Bubble frame, herringbone, and pass through the traction roller, guide roller until coiling. The manufacturer of bubble film roll making machine tells you that the compressed air pressure for inflating the tube blank should be appropriate, so as not to break the tube blank, but also to ensure the symmetry and stability of the film tube, which relatively ensures the quality of production.
Finally, when the extruder and die need to be cleaned after the operation, copper knives, rods or compressed air can be used for cleaning. The bubble film roll making machine manufacturer tells you not to damage the surface of the screw and screw, and keep the surface clean .